Chapter 4 Operation Interface｜VP3000
179
Motor parameter
auto-tuning
When the drive executes motor parameter auto-tuning, the status
column displays AutoT.
When the drive is in Base Block, the status column displays B.B.
When the drive is in sleep, the status column displays Sleep.
When the drive is in stall, the status column displays Stall.
When the motor executes pre-heating, the status column displays
PHeat.
When the drive is in flying start, the status column displays FlySr.
When the drive is in FireMode, the status column displays Fire.
Stop status +
forward operation
The drive is STOP and the operation direction is FWD, the operation
status displays FWDs.
Stop status +
reverse operation
The drive is STOP and the operation direction is REV, the operation
status displays REVs.
Switching from forward to reverse deceleration (follows REVa to
reverse)
Switching from reverse to forward deceleration (follows FWDa to
forward)
When the drive operates in FWD constant speed, the operation status
displays FWDn.
When the drive is in FWD acceleration, the operation status displays
FWDa.
When the drive is in FWD deceleration, the operation status displays
FWDd.
When the drive operates in REV constant speed, the operation status
displays REVn.
When the drive is in REV acceleration, the operation status displays
REVa.
When the drive is in REV deceleration, the operation status displays
REVd.
When the drive is in JOG forward, the operation status displays JOGf.
When the drive is in JOG reverse, the operation status displays JOGr.
When the drive operates with positive torque control, the operation
status displays PTQC.
When the drive operates with negative torque control, the operation
status displays NTQC.
To Next Page
Loading...
