Delta VP3000 Series - 2-4 Transportation and Installation; 2-4-1 Unpacking

Chapter 2 Mechanical Installation｜VP3000
11
2-4 Transportation and Installation
In order to ensure that the AC motor drive functions normally without risk of damage before installation, it
should be kept in the original packaging during transportation or storage, and make sure the surrounding
environmental conditions meet the specifications provided in this manual.
2-4-1 Unpacking
Follows the following steps for unpacking:
Frame G (Carton, applied for Frame A–G)
Frame L & M (Crate)
Step 1: Cut off all the packaging straps.
Step 1: Cut off all the packaging straps, and use
a flathead screwdriver to pry open all fasteners
on both sides of the crate.
Figure 2-8
Figure 2-9
Step 2: Remove the top cover, take out the
EPEs and the manual, and then loosen the
screws.
Figure 2-10
Step 2: Remove the top cover and take out the
manual.
Figure 2-11