Delta VP3000 Series - 2-4-5 Chassis Installation

Chapter 2 Mechanical Installation｜VP3000
19
2-4-5 Chassis Installation
Follow the following steps for installation (applicable for Frame L & M):
1. Use 10 pcs of M6 and 2 pcs of M8 screws to lock the track to the cabinet.
M6 Screw torque: 35–45 kg-cm / (30.4–39 lb-in.) / (3.4–4.4 Nm)
M8 Screw torque: 100–110 kg-cm / (86.8–95.5 lb-in.) / (9.8–10.8 Nm)
Figure 2-33
Figure 2-34
2. Lift the drive and place the front edge of the bottom against the end of the track, push the drive
into the cabinet along the track and lean to the bottom.
3. Use 4 pcs of M8 screws to lock the drive at the position indicated in the following figure.
M8 Screw torque: 100–110 kg-cm / (86.8–95.5 lb-in.) / (9.8–10.8 Nm)
Figure 2-35