Chapter 7 Second Development Platform VP3000
388
6. When Pr.o0-00 = 29, the display is the value of PLC register D1043, see the figures below:
Digital Keypad: KPV-CC01 Digital Keypad: KPV-CE02
Allowable display range: 0–65535
0–9999 Exceed 9999
7. In RUN mode of PLC or STOP mode of PLC, the setting value 9 and 10 of Pr.b0-01 cannot be
set, which means that cannot return to the default.
8. When Pr.b0-01 = 6, PLC can return to the default.
9. When PLC controls the operation of AC motor drive, the control command depends on whether
the associated flag of Pr.L0-02 allows the operation command to be from PLC.
10. When PLC controls the frequency of AC motor drive (FREQ instruction), the frequency command
depends on whether the associated flag of Pr.L0-02 allows the frequency command to be from
PLC.
11. When PLC controls the specific digital output terminals of AC motor drive, the command of the
specific digital output terminals depends on whether the associated flag of Pr.L0-04 allows their
command to be from PLC.
12. When PLC controls the specific analog output terminals of AC motor drive, the command of the
specific analog output terminals depends on whether the associated flag of Pr.L0-06 allows their
command to be from PLC.
13. When PLC controls the operation of AC motor drive, if set Pr.A4-12 (the STOP is valid for
keypad) at this moment, the stop is triggered when keypad gives order.
To Next Page
Loading...
