Delta VP3000 Series - Page 444

Chapter 8 Troubleshooting｜VP3000
435
ID No.
Warning Name
Descriptions
57
No end commands
(PLEd)
Program has no END stop command
Action and Reset
Action Condition
The “End” command is missing until the last command is executed, the PLEd
warning shows
Action Time
Immediately act when the error is detected
Warning Setting Parameter
N/A
Reset Method
Check if the program is correct and re-download the program. If the fault does
not exist, the warning automatically clears.
Reset Condition
No
Record
No
Cause
Corrective Actions
There is no “END” command
during PLC operation
Check if the PLC program is correct and re-download the program.