Delta VP3000 Series - Page 66

Chapter 2 Mechanical Installation｜VP3000
57
Frame I
Applicable models:
Open Type: VFD260VP43AFTCA, VFD310VP43AFTCA
Type 1: VFD260VP43BFTCA, VFD310VP43BFTCA, VFD260VP43BSTCA, VFD310VP43BSTCA
1. Refer to the following table for the assembling accessories, quantities and screw torque.
No.
Accessories
Qty (pcs)
1
Control clips
3
2
Screw M4xL20 (Screw torque: 14–16 kg-cm / 12.2–13.9 lb-in. / 1.37–1.57 Nm)
6
3
EMC plate
1
4
Screw M5xL10 (Screw torque: 24–26 kg-cm / 20.8–22.6 lb-in. / 2.35–2.55 Nm)
2
5
Screw M4xL33 (Screw torque: 14–16 kg-cm / 12.2–13.9 lb-in. / 1.37–1.57 Nm)
4
6
Output EMC clips
2
2. Fasten the accessories as shown in the figure below.
Figure 2-81
3. Install the above EMC plate and control clips onto the AC motor drive, refer to the installation
location shown in the figure below.
Figure 2-82