100
Open the screwdriving program you wish to delete by using the menu. Click on "Remove"
at the top right beside the button "Print View“.
IMPORTANT
A program step, a complete program or all programs are deleted
immediately without a confirmation prompt.
View/process a program step:
Select an available program step by clicking this step. The parameters of this step are
displayed. A new value can be directly entered in the input field next to the parameter.
Save program:
Click on the button "Save" that is located on the left side below the screwdriving samples
and commands, to save the program steps and general parameters.
To Next Page
Loading...
