Deprag AST40-1 User Manual

27
Sto2active BOOL
Emergency stop signal 2 is active
This signal has the status “high” when the Emergency Stop
circuit is functioning properly.
Reload BOOL
Reload signal
This signal is currently not available yet!
ProgOut1 BOOL
Output 1 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut2 BOOL
Output 2 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut3 BOOL
Output 3 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut4 BOOL
Output 4 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut5 BOOL
Output 5 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut6 BOOL
Output 6 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut7 BOOL
Output 7 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut8 BOOL
Output 8 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut9 BOOL
Output 9 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut10 BOOL
Output 10 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut11 BOOL
Output 11 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.
ProgOut12 BOOL
Output 12 from the screwdriver program
This output can be set or reset and queries in the SPS in
the screwdriving program of the AST40 sequence
controller.

Deprag AST40-1 Specifications

General

Brand	Deprag
Model	AST40-1
Category	Controller
Language	English