85
The following data can also be added:
• all the screwdriving programs
• screwdriving results
• curve displays on the latest screw assemblies.
IMPORTANT
It is urgently recommended that all available data be included in the
system mapping.
System mapping procedure:
1. Plug in an USB stick
2. Press on "Generate".
3. Wait until you see that the system map was copied to the USB stick.
4. Then unplug the USB stick and send it to your DEPRAG consultant or directly to
DEPRAG SCHULZ GMBH u. CO.
To Next Page
Loading...
Need help?
General
