Control 24 Reference Guide128
5 Rotate the channel encoder to write automa-
tion moves. Following all Pro Tools settings for
touch time-out and thinning, automation will
be recorded to the plug-in automation playlist.
6 You can punch-out of automation recording
at any time by pressing the appropriate AUTO-
MATION ENABLE switch.
Automating Plug-In Flip Mode
To enable plug-in automation in Plug-In Flip mode:
1 Make sure the plug-in’s track is in an automa-
tion writing mode (Write, Touch, or Latch, or a
Trim mode).
2 Make sure that plug-in automation recording
is enabled (the PLUG-IN button should be flash-
ing in the ENABLE column of the master AUTO-
MATION section).
3 Press a channel AUTO button, corresponding
to the plug-in parameter you want to automate.
When a parameter is armed for automation, the
AUTO LED flashes. When a write pass is under-
way, the AUTO LED remains lit.
If the automation mode is TOUCH, after the
fader is released and the touch timeout period is
reached, the fader will return to the previous
value or automation and the AUTO LED will be-
gin to flash again, indicating that the touch pass
is over.
If you want to add additional automation
moves or augment your previous pass, fol-
low the previous procedure but select Auto
Touch or Auto Latch modes. These enable
you to add new automation only when you
actually move an encoder knob.
Control_24.book Page 128 Wednesday, January 17, 2001 2:51 AM
To Next Page
Loading...
Need help?
General
