3. Amp Control Buttons
The four AMP CONTROL buttons are used to select one of the amp/cabinet model
edit rows including: CHAN ONE EQ
(Green), GENETX (Yellow), CHAN TWO EQ
(Red), and TONE (Silver).
4. Status button
The STATUS button has multiple functions that depend on the matrix row that is
selected. For example:
With the CHAN ONE EQ (Green) row selected, the STATUS
button turns Channel
One’s EQ on and off.
With the
GENETX (Yellow) amp/cabinet model row selected, the STATUS button
selects which amp you are listening to: Channel One, Channel Two, or the Warped
Amp (if a Warped state between both channels exists).
With the CHAN TWO EQ (Red) row selected, the STATUS
button turns Channel
Two’s EQ on and off.
With the TONE (Silver) row selected, the STATUS
button selects which amp you are
listening to: Channel One, Channel Two, or the Warped Amp (if a Warped state
between both channels exists). The Amp Gain, Bass, Midrange, Treble, and Amp
Levels alternate between editing Channel One’s (lit green) or Channel Two’s (lit
red) amp settings as the STATUS
button is pressed.
When editing effects in the Effect Matrix, the STATUS button turns the selected
effect on and off, or selects a controller type for the expression assignment.
5. Knobs 1-5
After selecting one of the rows using the AMP CONTROL or EFFECT SELECT buttons,
these five knobs adjust the parameters listed in the column directly above or below
each knob.
6. Matrix
a. GeNetX™ Amp Controls Matrix
The GeNetX Amp Controls Matrix lists the Channel One and Channel Two
amp types, cabinet types, EQ/tone controls, and cabinet tuning parameters
available for editing in each preset.
b. Effects Matrix
The Effects Matrix lists the effects and effect parameters available for editing
in each preset.
GNX3000 Owner’s Manual
13
GNX3000 Owner’s Manual
To Next Page
Loading...
Need help?
General
