Dräger Perseus A500 - Customizing the Current View; Using Loops

Operation
106 Instructions for use Perseus A500 SW 2.0n
Customizing the current view
The monitoring area can be customized during
operation:
1 Touch a waveform or parameter field. The
Quick setup window opens.
2 For Content (A), select the desired content
from the list.
For a list of the possible screen content, see
page 173.
3 For Scale (B), select the desired scale.
Restoring the current view
The changes in the current view can be reset to
the saved standard.
1 Open the Views dialog window.
2 Touch the Restore current view button.
Using loops
The following loops are available:
– Pressure-Volume loop
– Flow-Volume loop
1 Open the Views dialog window.
2 Touch the Loops button.
The following is displayed:
A Current loop and the last 5 loops
B Parameters:
– Cdyn
– R
– TC
The area (E) can be configured so that the
Pressure-Volume loop is displayed.
10402
WARNING
Risk of insufficient monitoring
National and medical regulations require
certain parameters to be displayed.
Always consider the relevant regulations
when configuring the screen layout.
B
A
Quick setup
1047631735
A
B
C
D
E