Dräger Perseus A500 - Mounting of accessories

Instructions for use Perseus A500 SW 2.0n 49
Assembly and preparation
Mounting of accessories
Information on mounting accessories is described
in the assembly instructions.
Safety information
Mounting on the sides of the device
column
Depending on the arm length, the following
maximum weights are permissible:
Note the following information in addition:
– If more than one arm is installed on a device
side, the weights or arm lengths must be
reduced. Do not exceed the maximum tilting
moment.
– Maximum weight on the right side of the
device: 35 kg (77 lbs)
– Maximum weight on the left side of the device:
– Versions with plug-in connections for
2 vaporizers: 25 kg (55 lbs)
– Versions with plug-in connections for
3 vaporizers: 15 kg (33 lbs)
– Maximum installation height: 1400 mm
(55.1 in)
The maximum tilting moment is calculated based
on the following equation:
Explanation:
CAUTION
Risk of tipping over
When support arms are used, the end stops must
be in perfect condition. Otherwise there is a risk
that the support arms will swing out of control.
Check the functional integrity of the support arm
end stops after the following activities:
– After fitting accessories
– After transporting the device
Arm
length
Maximum weight
Version with
plug-in connec-
tions for 2
vaporizers
Version with
plug-in connec-
tions for 3
vaporizers
215 mm
(8.5 in)
20 kg
(44 lbs)
13.5 kg
(29.8 lbs)
300 mm
(11.8 in)
15 kg
(33 lbs)
8.5 kg
(18.7 lbs)
400 mm
(15.7 in)
15 kg
(33 lbs)
8.5 kg
(18.7 lbs)
570 mm
(22.4 in)
15 kg
(33 lbs)
8.5 kg
(18.7 lbs)
Variants with plug-in connections for 2 vaporizers:
One attached
component:
P= (A * B) <8500 mm*kg
(<738 in*lbs)
Multiple attached
components:
P1 + P2 + P... <8500 mm*kg
(<738 in*lbs)
Versions with plug-in connections for 3 vaporizers:
One attached
component:
P= (A * B) <5000 mm*kg
(<434 in*lbs)
Multiple attached
components:
P1 + P2 + P... <5000 mm*kg
(<434 in*lbs)
A: Distance (including arm length) to outer edge
of the attached component
B: Arm weight (B1) + weight of attached compo-
nent (B2)
P: Product of distance and weight