Dräger Perseus A500 - Displaying Additional Data; Changing the Color Scheme and the Screen Brightness; Viewing Current Measured Values; Logbook

Operation
108 Instructions for use Perseus A500 SW 2.0n
Changing the color scheme and the
screen brightness
1 Open the System setup dialog window.
2 Touch the Screen layout > General tab (A).
3 To change the color scheme, touch one of the
buttons at (B).
4 Set the screen brightness at (C).
Displaying additional data
Viewing current measured values
During operation, measured values for ventilation,
gases, and the device are available in tabular
overviews.
1 Open the Trends/Data dialog window.
2 Touch the Values tab (A).
The vertical tabs (B) display different combinations
of parameters.
Logbook
The logbook can save up to a maximum of 20000
entries. Logbook data are displayed in table form.
1 Open the Trends/Data dialog window.
2 Touch the Logbook tab (A).
Use the rotary knob or the arrow buttons to scroll
the cursor (B) up (C) or down (D) in the logbook.
To scroll quickly, touch the gray area (E).
10479
A
B
C
A
System setup
10497
A
B
Trends/Data
10480
A
B
C
E
D
Trends/Data