Dräger Perseus A500 - Resetting the Start Settings; Resetting the Consumptions; General Device Information

Configuration
170 Instructions for use Perseus A500 SW 2.0n
Resetting the start settings
Certain tabs in the System setup dialog window
have a button for resetting the respective start
settings to the factory settings.
Resetting the changes in a dialog window
1 Open the corresponding tab.
2 Touch the Factory defaults button and
confirm.
Resetting the consumptions
The gas consumption can be reset in Standby >
System setup > System status > Consumption.
 Touch the Reset data button and confirm.
General device information
Further information is displayed in Standby >
System setup > System status:
A General information
– Installed software version
– Next maintenance date
B QR code for further product information
 Scan the QR code with suitable equipment.
The QR code is decoded into an internet address
which enables access to the stated information in a
browser.
31778
A
B
System setup