vi
Safety Summary, Continued
Safety
precautions
The following safety precautions must be followed whenever any type of voltage or
current connection is being made to the HDPQ Xplorer.
• Review NFPA70-E Standard for Electrical Safety Requirements for Employee
Workplaces for applicable safety requirements for potential electrical hazards that
may be encountered.
• Wear proper Personal Protective Equipment, including safety glasses and insulated
gloves when making connections to power circuits.
• Hands, shoes and floor must be dry when making any connection to a power line.
• Before each use, inspect all cables for breaks or cracks in the insulation. Replace
immediately if defective.
• Press the HDPQ Xplorer On/Off power switch to Off.
• Before connecting to electric circuits to be monitored, open their related circuit
breakers or disconnects. DO NOT install any connection of the HDPQ Xplorer to
live power lines.
• Connections must be made to the HDPQ Xplorer first, then connect to the circuit to
be monitored.
• If the equipment is used in a manner not specified in this User Guide, the protection
provided by the equipment may be impaired.
These safety precautions are repeated where appropriate throughout this manual.
Shop for Power Metering products online at:
1.877.766.5412
www.PowerMeterStore.com
To Next Page
Loading...
