ECKELMANN Case Controller UA 4 E Series - Function of the Analogue Outputs 0

Firmware V3.13
21.04.2021
104/466
•
5.12 Function of the analogue outputs 0..10 V.
Only UA 410 E AC
The function of the two analogue outputs AO1 and AO2 (0..10 V) can be configured using the DIP switch S3
coding switch 6:
Output of the opening degree (coding switch 6 = OFF, factory setting)
Theoutputoftheopeningdegree0..100%(correspondsto0..10V)atthetwoanalogueoutputsforthe
control of continuous expansion valves for the zones 1/2: for details, see chapter Control of the expansion
valves.
ATTENTION
Damage to the installation and stock loss! The changeover of the analogue outputs is only intended
for trained personnel as changes can affect other functions.
