ECKELMANN Case Controller UA 4 E Series - Basic Configuration of the Controller

Firmware V3.13
21.04.2021
132/466
6.4 Basic configuration of the controller
The lock-down must previously be deactivated on the higher level controller (system centre / store computer or
operator terminal) so that configuration settings can be made on the controller.
1.Cancellingentryblock
A.BT300operatorinterface;fordetails,seechapterLock-down of the setpoint change
B. System centre via Login symbol; for details, see chapter System Centre.
C. Store computer / operator terminal Menu 9-3; for details, see chapter Store computer CI 3x00 / operator
terminal AL 300.
2. Opening main menu of the controller
A. The main menu of the controller is shown directly in the operator interface.
B. In the system centre, select the required controller in Menu 4-2 and then tap the Remote Control button to
display the main menu of the controller.
C. In the store computer and operator terminal, a selection list of all CAN bus components is displayed in Menu
5 Remote Control. Select the controller with the corresponding CAN bus address (Kn,nnn = 1..99) to be
parametrised in the selection list using the cursor or direct input and recall by tapping the ENTER button so that
the main menu of the controller is displayed.