ECKELMANN Case Controller UA 4 E Series - Page 106

Firmware V3.13
21.04.2021
106/466
Theon/offcommandisissuedbyahigherordercontroller(e.g.systemcentre/storecomputer/PLC)viathe
CANBus.Theparameterisationiscarriedoutonthehigherordercontroller,thecasecontrollerdoesn'trequire
parameterisation.Theconditionoftheoutputisdisplayedinthemenu1-2(”StatuslightON/OFF”).
The higher order controller must support this function.
