ECKELMANN Case Controller UA 4 E Series - Page 222

Firmware V3.13
21.04.2021
222/466
•
•
Menu 6-3 Cooling
COOLING POS: XXXXX Entry Default
corr.off to XX K Correction offset for pressure loss in suction line
IMPORTANT: in stand alone operation must be set to
”--”!
--, 0..20 2 K
Cont Cool Mon. XX m Continuous run monitoring --, 0..15 ---
EnablingRel XXX Switchingto“EnableOperation“:
OFFOpeningdegreeistransmittedviathesolid
state relay (SSR)
ONThetwoSSRsarenolongerclocking,theyare
switched on if the case controller requires refrigeration,
i.e. switched off again if no refrigeration is required.
↑,↓,
(ON/OFF)
OFF
Menu 6-4 Language
LANGUAGE POS: XXXXX Entry Default
DeutschD√ √
English GB
Francais F
Espanyol ESP
Finnish FIN
Cesky CZ