ECKELMANN Case Controller UA 4 E Series - Page 340

Firmware V3.13
21.04.2021
340/466
•
•
Menu 6-3 Cooling
COOLING POS: XXXXX  Entry Default
corr.off to XX K Correction offset for pressure loss in suction line
IMPORTANT:instandaloneoperationmustbesetto”--”!
--, 0..20 2 K
Cont Cool Mon. XX m Continuous run monitoring --, 0..15 0 min
EnablingRel XXX Switchingto“EnableOperation“:
OFF Opening degree is transmitted via the solid state
relay (SSR) ON The two SSRs are no longer clocking,
they are switched on if the case controller requires
refrigeration, i.e. switched off again if no refrigeration is
required.
↑,↓
(ON/OFF)
OFF
Menu 6-4 Language
Selection is made according to entry. Checkmark shows current setting.
LANGUAGE POS: XXXXX Entry Default
Deutsch D
English GB 
Francais F 
Espanyol ESP 
Finnish FIN 
Cesky CZ 