ECKELMANN Case Controller UA 4 E Series - Page 382

Firmware V3.13
21.04.2021
382/466
•
•
Menu 6-3 Cooling
COOLING POS: XXXXX Entry Default
corr.off to XX K Correction offset for pressure loss in suction line
IMPORTANT: in stand alone operation must be
setto”--”!
--, 0..20 2 K
Cont Cool Mon. XX m Continuous run monitoring --, 0..15 0 min
EnablingRel XXX Switchingto“EnableOperation“:
OFF Opening degree is transmitted via the solid
state relay (SSR)
ON The two SSRs are no longer clocking,
they are switched on if the case controller
requires refrigeration, i.e. switched off again
if no refrigeration is required.
↑,↓
(ON/OFF)
OFF
Menu 6-4 Language
Selection is made according to entry. Checkmark shows current setting.
LANGUAGE POS: XXXXX Entry Default
Deutsch D
English GB
Francais F
Espanyol ESP
Finnish FIN
Cesky CZ