If the user receives a confirmation prompt to install the driver, select Install.
Figure 78 – Installing Driver Confirmation Prompt
If everything went smoothly, Windows will inform the user that the driver was successfully installed.
Figure 79 – Successful Driver Installation
4.6.1.2 Connecting Over Serial (RS-232)
The following steps outline how to setup the instrument for connection to a PC or datalogger (refer to
Section 3.4.25).
Procedure
1. Open - Main Menu → Communication Menu → Serial Communication Menu.
2. Determine which RS232 Port the user is physically making the connection with. Remember,
multidrop is only supported on RS232 #2.
3. Select – Baudrate → 38400 - Accept (Set an appropriate baud rate, default is 38400).
4. Select - Protocol → Advanced - Accept.
To Next Page
Loading...
