2.5 EN Type Approval Set-Up
The Serinus 10 has been certified to TÜV performance standards for Continuous Ambient Air Quality
Monitoring Systems. The certificate number is TÜV 936/21221977/C. The Serinus 10 must be used
under the following conditions to meet EN requirements:
Range
0 - 250 ppb
Ambient Temperature
0 - 30 °C
Instrument Settings
The instrument must be operated and maintained in accordance with this user manual.
The following menu selections must be used:
Calibration Menu
Span Comp: Disabled
Diagnostics Menu
Pres/Temp/Flow Comp: ON
Diagnostic Mode: Operate
Control Loop: Enabled
2.6 Transporting/Storage
Transporting the Serinus should be done with great care. It is recommended that the packaging the
Serinus was delivered in should be used when transporting or storing the instrument.
When transporting or storing the instrument the following points should be followed:
1. Turn OFF the instrument and allow it to cool down.
2. Remove all connections of pneumatic pipe, power cables and communication cables from the
instrument.
3. If storing over a long period (six months) turn the battery OFF by moving the switch (S1) on the
main controller PCA (refer to Figure 25).
4. Remove the instrument from the rack.
To Next Page
Loading...
