Ecotech Acoem Serinus 10 - Figure 20 - Dust Plugs; Figure 21 - Remove Nut; Figure 22 - Insert Tube

Installation/Decommission
Page 41
Procedure
1. Remove all the dust plugs.
Figure 20 – Dust Plugs
2. Remove the sample port nut.
Figure 21 – Remove Nut
3. Insert the tubing through the back of the nut with the tube extending one inch through the front.
Figure 22 – Insert Tube
4. Place the tubing into the port until it hits the tube stop located inside the fitting.