Ecotech Acoem Serinus 10 - Figure 26 - Dust Plugs

Serinus® 10 User Manual 3.2
Page 46
5. Seal each pneumatic port with a dust plug (refer to Figure 26).
Figure 26 – Dust Plugs
6. Remove the USB memory stick and pack with instrument (refer to Figure 24).
7. Place the instrument back into a plastic bag with desiccant packs and seal the bag (ideally the bag
it was delivered in).
8. Place the instrument back into the original foam and box it was delivered in. If this is no longer
available find some equivalent packaging which provides protection from damage (refer to
Figure 27).
Note: Ecotech recommended to use the same packing material in which instrument is delivered.
9. The instrument is now ready for long term storage or transportation.
Note: After transport or storage the instrument must be set-up and calibrated (refer to
Section 2.3.4).