Ecotech Acoem Serinus 10 - Data Logging Menu; Serial Communication Menu; Figure 53 - Data Logging Menu Screen; Figure 54 - Serial Communication Menu Screen

Serinus® 10 User Manual 3.2
Page 78
3.4.24 Data Logging Menu
Figure 53 – Data Logging Menu Screen
Main Menu → Communications Menu → Data Logging Menu
When editing the numeric or text menus, the “-” key will delete the current parameter and move the
others up to take its place; the “+” key will insert a parameter at the current location and move the
ones below it down. The internal logger can log a maximum of 12 parameters.
Data Log Interval
Displays the interval at which the data is saved to the USB memory
stick. Selecting a 1 sec interval may result in occasional
measurements not being logged or slow response to serial
commands.
Cal. Log Interval
When enabled displays the interval at which the data is saved to
the USB memory stick for the calibration time period. This occurs
when the system is in Cal. Mode SPAN or ZERO. Selecting a 1 sec
interval may result in occasional measurements not being logged
or slow response to serial commands. Seconds (1, 2, 5, 10, 15, 30)
or Minutes (1, 2, 3, 5, 10, 15, 20 or 30) or hours (1, 2, 4, 6, 8, 12 or
24). Default is Disabled.
Data Log Setup – Numeric
Numeric list of the parameters logged. This is a quicker way to
enter parameters (for lists of parameters refer to Table 25).
Data Log Setup – Text
Select the list of logged parameters by name.
3.4.25 Serial Communication Menu
Figure 54 – Serial Communication Menu Screen