3.4.33 Chart
Main Menu → Trend Display Menu → Chart
The chart allows the user to select a parameter and view it in a real time chart. The user can select
from any loggable parameter (refer to Table 25). Changing the logged parameter will reset the chart.
Pressing the Up or Down buttons will change between the selected parameter and the instantaneous
Ozone gas value. Changing the Data Log Interval resets all charts.
Figure 62 – Chart Screen
Chart Title (1)
Displays the name of the parameter as it would be displayed on the advanced protocol parameter list.
Data Log Interval (2)
Displays the value of the data logging interval as determined by the user in the Trend Display Menu
(refer to Section 3.4.32).
Chart X-Axis (3 & 4)
(3) Displays the time stamp for the oldest data point (left hand side).
(4) Displays the time stamp for the newest data point (right hand side) or if the cursor is active it
displays the current cursor data point time stamp.
Chart Y-Axis (5 & 6)
(5) This is the minimum scale as defined by the autoscale or the user (refer to Section 3.4.32).
(6) This is the maximum scale as defined by the autoscale or the user (refer to Section 3.4.32).
Current Data Point Value (7)
Displays the current value of the newest data point unless the cursor is active then is displays the
current cursor data point value.
Units (8)
Displays the units of measure for the parameter that the user has selected.
To Next Page
Loading...
