Ecotech Acoem Serinus 10 - Figure 81 - Adding a New Station; Figure 82 - New Station Connection; Table 8 - New Station Setup

Serinus® 10 User Manual 3.2
Page 106
3. Once the Client application has loaded, click Home → Add Station → New Physical Station.
Figure 81 – Adding a New Station
4. This automatically brings the user to the Station tab on the ribbon. Enter the communication
details to connect to the instrument.
Figure 82 – New Station Connection
Table 8 – New Station Setup
Property
Description
Station Name
The name of the station. If the user has other loggers, the name is used to distinguish
them.
Logger
Set this to “Ecotech Serinus” when downloading from any Serinus series instrument. This
will communicate with the instrument via the Advanced protocol. If using a network or
serial connection, ensure that the Advanced protocol has also been selected on the
instrument itself.
Time Zone
Set this to the time zone that the instrument is located in.
DST
Enable this option if the user plan on changing the clock on the instrument with daylight
savings. Leave this disabled if the clock does not shift during DST. The instrument will
need to be adjusted manually for DST – it will not happen automatically.
Database
Name
This is the name to be used for the table in the SQL database containing this station’s
data. It must be unique for each station.