Ecotech Acoem Serinus 10 - Figure 117 - Remove Filter Sealing Cap; Figure 118 - Particulate Filter

Service
Page 143
5. Remove the sample filter holder sealing cap.
Figure 117 – Remove Filter Sealing Cap
6. Remove the old particulate filter.
Figure 118 – Particulate Filter
7. If the inner surface of the sample filter components are dirty, then clean with damp lint free paper
towel.
8. Place a new particulate filter paper into the body of the sample filter holder.
Note: Make sure filter body is completely dry before placing the new filter.
Note: Avoid to touch Particulate filter paper by hand use blue paper to place the filter into filter
body.