Ecotech Acoem Serinus 10 - Figure 140 - Remove Lamp Mounting Block; Figure 141 - Remove Kynar Elbow Fitting

Serinus® 10 User Manual 3.2
Page 158
6. Now that we have isolated the lamp block, remove the screw to dismantle the lamp mounting
block.
Note: Be careful while dismantling lamp mounting block Quartz Window may fall on the ground.
Figure 140 – Remove Lamp Mounting Block
7. Remove the Kynar elbow fitting from the lamp block by turning counter-clockwise.
Figure 141 – Remove Kynar Elbow Fitting
8. Remove the spring.
9. Remove the orifice by screwing in the orifice removal tool (finer thread end) clockwise, then gently
pulling out the orifice.