Ecotech Acoem Serinus 10 - Main Controller PCA; Pneumatic Tubing; Rear Panel; Figure 8 - Ecotech Tubing

Serinus® 10 User Manual 3.2
Page 30
measurement cell. This pressure reading is used to verify sample flow and correct measurement
readings for pressure variations.
1.5.5 Main Controller PCA
Refer to Figure 1 for the location of main controller PCA. The main controller PCA controls all the
processes within the instrument. As well as the on-board microprocessor, it contains a battery backed
clock, calendar analog to digital converters and many other circuits for signal processing and control.
The ambient pressure and chassis temperature sensors are also located on this board. The main
controller PCA is located above all other components within the instrument. It pivots on hinges to allow
access to the components underneath.
CAUTION
Never place objects on top of the main controller PCA as it may result in
damage.
1.5.6 Pneumatic Tubing
The pneumatic tubing inside this instrument is specially designed for use in Ecotech Serinus
instruments. It has the flexibility of Silicone tubing with the added inner sheath of PVDF to prevent
contamination of the sample. Care should be taken when removing and inserting the tubing into the
barbed fittings.
Figure 8 – Ecotech Tubing
1.5.7 Rear Panel
Figure 9 – Rear Panel