Ecotech Acoem Serinus 10 - Trend Display Menu; Figure 61 - Trend Display Menu Screen

Serinus® 10 User Manual 3.2
Page 86
Reset
After changing the ID or PIN, it is necessary to reboot the
Bluetooth module. This is done by resetting the instrument or
by using this menu item to reboot only the Bluetooth.
ID
This is the Bluetooth ID of the instrument. Use the keypad to
edit this field (refer to Section 3.3.1 for instructions on
entering text with the numeric keypad).
The default ID setting is Serinus (Ecotech ID).
The word Serinus is always the first part of the name and
cannot be edited. The second part is the Ecotech ID.
3.4.32 Trend Display Menu
Figure 61 – Trend Display Menu Screen
Main Menu → Trend Display Menu
Name
Displays the name of the Parameter the user has selected.
Parameter
Allows the user to select any loggable (refer to Table 25)
parameter to graph on the trend display.
Autoscale
Autoscale can be ON or OFF. When it is “ON” the parameter
will be scaled automatically for user convenience based on the
current values logged.
Min
This is the minimum scale of the chart as defined by the
Autoscale or the user.
Max
This is the maximum scale of the chart as defined by the
Autoscale or the user.
Clear
Clears the current data points in the Chart.
Data Log Interval
The data log interval can be user set from 1 sec interval up to
24 hours.
Chart
This field enters a screen with a graph of the user selected
Parameter (refer to Section 3.4.33).