Ecotech Acoem Serinus 10 - Bluetooth Menu; Figure 60 - Bluetooth Menu Screen

Operation
Page 85
IP Address
[Read or Set mode]
This is the current IP address of the instrument.
Netmask
[Read or Set mode]
This is the subnet mask of the network the instrument is
connected to.
Gateway
[Read or Set mode]
This is the IP address of the router to access addresses not on the
same subnet.
Adaptor is in DHCP mode
[DHCP mode]
In this mode the instrument will ask for its network parameters
from a DHCP server on your network.
Protocol
Sets the protocol used for the network port (Advanced, ModBus,
EC9800 or Bayern-Hessen). This must be set to Advanced for
Ecotech supplied software.
Endian
[Protocol Modbus]
Select Little or Big endian mode for ModBus protocol.
Bayern-Hessen Serial ID
[Protocol Bayern-Hessen]
This is the Bayern-Hessen ID used by the Bayern-Hessen Protocol.
O3 ID
[Protocol Bayern-Hessen]
This is the ID of the O3 gas used by the Bayern-Hessen Protocol.
To read the IP address, refer to Section 4.3.1.
To set the IP address, refer to Section 4.3.2.
3.4.31 Bluetooth Menu
Figure 60 – Bluetooth Menu Screen
Main Menu → Communications Menu → Bluetooth Menu
This instrument supports Bluetooth communication through the Serinus Remote Android Application
(refer to Section 4.7).
Bluetooth
This field indicates whether the instrument is remotely
connected to an Android device.