Ecotech Acoem Serinus 10 - Pressure & Flow Menu; Figure 35 - Pressure & Flow Menu Screen

Serinus® 10 User Manual 3.2
Page 60
Main Menu → Analyser State Menu → Temperature Menu
Temperature Units
The current temperature units of the instrument (Celsius,
Fahrenheit or Kelvin).
Set Point (LAMP)
The temperature set point of the UV lamp. The factory default is
50 °C.
Set Point (FLOW)
[Internal pump option]
The temperature set point of the flow block heater. The factory
default is 50 °C.
Set Point (O3 GEN.)
[IZS option]
The temperature set point of the Ozone generating lamp. The
factory default is 50 °C.
Lamp
Displays current temperature of the UV lamp.
Flow block
[Internal pump option]
Displays the current temperature of the flow block.
Chassis
Displays the temperature of air inside the chassis, measured on
the main controller PCA board.
O3 Gen.
[IZS option]
The current temperature of the Ozone generator.
Chassis Humidity
Displays the humidity percentage of air inside the chassis,
measured on the main controller PCA board.
3.4.6 Pressure & Flow Menu
Figure 35 – Pressure & Flow Menu Screen
Main Menu → Analyser State Menu → Pressure & Flow Menu
Pressure Units
Select the units that the pressure will be displayed in (torr, PSI,
mBar, ATM or kPa).
Ambient
Current ambient pressure.
Cell
Current pressure within the optical cell.
Flow Units
Select the units that the flow will be displayed in (slpm or L/min).
Flow Set Point
[Internal Pump Option]
The desired sample flow. If the user has IZS option and changes
the flow set point, then the user will need to recalibrate the Ozone
generator.