Ecotech Acoem Serinus 10 - Internal Pump (PN: E020105); Hardware Setup; Internal Pump Additional Components; Table 12 - Internal Pump Components

Serinus® 10 User Manual 3.2
Page 178
8.4 Internal Pump (PN: E020105)
Note: Serinus 10 with both IZS and Internal Pump options is currently under development. Contact
Ecotech for more information.
8.4.1 Hardware Setup
This procedure should be followed after a factory reset.
Procedure
1. Press - (the green instrument status light), this will take you to the home screen.
2. Press - (-99+) on the keypad. This will open the Advanced Menu.
3. Open - Advanced Menu → Hardware Menu.
4. Enable - Internal Pump → Enabled.
8.4.2 Internal Pump Additional Components
The Serinus 10 internal pump option includes the following components:
Table 12 – Internal Pump Components
Component
Description
Part number
Internal Pump
Draws sample through the instrument
H010027
Flow Block
Includes sintered filter and differential pressure
sensor to measure flow.
H010120
Heater and Thermistor
Mounted in flow block to measure and control
temperature for accurate flow measurement.
Installed in flow
block
Gasket
Used to thermally isolate the flow block assembly
from the Serinus chassis.
H010119
Pressure Cable
Used to connect differential pressure PCA of the
flow block to main controller PCA.
C020062-02
Heater thermistor Cable
Used to connect heater thermistor assembly of the
flow block to the main controller PCA.
C020083
Stop Valve
Valve used to isolate pump from the pneumatic
circuit of the instrument.
H030170
Bypass Coil
Bypass coil for pump flow correction.
TUB-1000 (800 mm)