Ecotech Acoem Serinus 10 - Hardware Setup; Rack Mount Kit (PN: E020116); Figure 150 - Separate Rack Slides; Table 11 - Included Parts (Rack Mount Kit)

Serinus® 10 User Manual 3.2
Page 174
8.2.1 Hardware Setup
This procedure will need to be followed after a factory reset.
Procedure
1. Press - (the green instrument status light button), this will take user to the home screen.
2. Press - (-99+) on the keypad. This will open the Advanced Menu.
3. Open - Advanced Menu → Hardware Menu.
4. Enable - Network Port → Enabled.
8.3 Rack Mount Kit (PN: E020116)
The rack mount kit is necessary for installing the Serinus into a 19” rack (the Serinus is 4RU in height).
Table 11 – Included Parts (Rack Mount Kit)
Description
Quantity
Part Number
Rack Slide Set
1
H010112
Rack Mount Adaptors
4
H010133
Rack Mount Ears
2
H010134
Spacers
4
HAR-8700
M6 x 20 Button Head Screws
8
M6 Washers
16
M6 Nyloc Nuts
8
M4 x 10 Button Head Screws
18
M4 Washers
8
M4 Nyloc Nuts
8
M6 Cage Nuts
8
Installing the Instrument
1. Remove the rubber feet from the instrument (if attached).
2. Separate the slide rail assembly by pressing the black plastic clips in the slide rails to remove the
inner section of the rail (refer to Figure 150).
Figure 150 – Separate Rack Slides