C
HAPTER
20
| System Management Commands
Time
– 751 –
RELATED COMMANDS
sntp server (751)
sntp poll (751)
show sntp (752)
sntp poll This command sets the interval between sending time requests when the
switch is set to SNTP client mode. Use the no form to restore to the
default.
SYNTAX
sntp poll seconds
no sntp poll
seconds - Interval between time requests.
(Range: 16-16384 seconds)
DEFAULT SETTING
16 seconds
COMMAND MODE
Global Configuration
EXAMPLE
Console(config)#sntp poll 60
Console#
RELATED COMMANDS
sntp client (750)
sntp server This command sets the IP address of the servers to which SNTP time
requests are issued. Use the this command with no arguments to clear all
time servers from the current list. Use the no form to clear all time servers
from the current list, or to clear a specific server.
SYNTAX
sntp server [ip1 [ip2 [ip3]]]
no sntp server [ip1 [ip2 [ip3]]]
ip - IP address of a time server (NTP or SNTP).
(Range: 1 - 3 addresses)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
To Next Page
Loading...
Need help?
General
