C
HAPTER
20
| System Management Commands
Time
– 752 –
COMMAND USAGE
This command specifies time servers from which the switch will poll for
time updates when set to SNTP client mode. The client will poll the time
servers in the order specified until a response is received. It issues time
synchronization requests based on the interval set via the sntp poll
command.
EXAMPLE
Console(config)#sntp server 10.1.0.19
Console#
RELATED COMMANDS
sntp client (750)
sntp poll (751)
show sntp (752)
show sntp This command displays the current time and configuration settings for the
SNTP client, and indicates whether or not the local time has been properly
updated.
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
This command displays the current time, the poll interval used for sending
time synchronization requests, and the current SNTP mode (i.e., unicast).
EXAMPLE
Console#show sntp
Current Time : Nov 5 18:51:22 2006
Poll Interval : 16 seconds
Current Mode : Unicast
SNTP Status : Enabled
SNTP Server : 137.92.140.80 0.0.0.0 0.0.0.0
Current Server : 137.92.140.80
Console#
NTP Commands
ntp authenticate This command enables authentication for NTP client-server
communications. Use the no form to disable authentication.
SYNTAX
[no] ntp authenticate
DEFAULT SETTING
Disabled
To Next Page
Loading...
Need help?
General
