C
HAPTER
23
| Authentication Commands
Web Server
– 827 –
COMMAND USAGE
â—† You cannot configure the HTTP and HTTPS servers to use the same
port.
â—† If you change the HTTPS port number, clients attempting to connect to
the HTTPS server must specify the port number in the URL, in this
format: https://device:port_number
EXAMPLE
Console(config)#ip http secure-port 1000
Console(config)#
RELATED COMMANDS
ip http secure-server (827)
show system (711)
ip http
secure-server
This command enables the secure hypertext transfer protocol (HTTPS) over
the Secure Socket Layer (SSL), providing secure access (i.e., an encrypted
connection) to the switch’s web interface. Use the no form to disable this
function.
SYNTAX
[no] ip http secure-server
DEFAULT SETTING
Disabled
COMMAND MODE
Global Configuration
COMMAND USAGE
â—† Both HTTP and HTTPS service can be enabled independently on the
switch. However, you cannot configure the HTTP and HTTPS servers to
use the same UDP port.
â—† If you enable HTTPS, you must indicate this in the URL that you specify
in your browser: https://device[:port_number]
â—† When you start HTTPS, the connection is established in this way:
â–
The client authenticates the server using the server’s digital
certificate.
â–
The client and server negotiate a set of security protocols to use for
the connection.
â–
The client and server generate session keys for encrypting and
decrypting data.
To Next Page
Loading...
Need help?
General
