User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-85
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
MODE displays configuration of TL1 port settings
NETWORK list NETWORK type commands
NODE list NODE type commands
OPTIONS list options installed
PERIODS list time periods
PHONE show user phone numbers
POWER <t<n>> list power consumption data
PRCONFIG list channel configuration
PROGRAM list control programs
RATE list size or capacity percentages
REPORT show system alarm reporting parameters
SCAN list active channel status
SEQUENCE show AC & Standby sequencer status
SET list SET type commands
SNMP display the current value of the SNMP options
STATS list channel statistics
STATUS <n> show status page
TIME show date and time
TIMEOUT show user timeout
TRAPS display the SNMP TRAP information
UNIT show unit name and number
UPLOAD configure the system by uploading a file using XMODEM
UPLOAD TFTP allows transfer of configuration information to the system
from any networked personal computer capable of uploading
and downloading a file to a disk using the TFTP Protocol
USERS <n> list user configuration
VI show Plant Voltage and Load
CLR ACO disable alarm cutoff
CLR EVENTS clear event log
CLR LED <n> turn LED off
CLR LOG clear alarm log
CLR MAIL clear your mail from memory
CLR POWER <n> clear power consumption data
CLR PROGRAM <tn> clear control programs
CLR RLY <n> de-energize relay
CLR STATS <tn> clear channel statistics
IP ADD <address> add a new host to the list of authorized hosts
IP ADDRESS <address> set the units IP address
IP DELETE <address> remove a host from the list of authorized hosts
IP GATEWAY <address> set the units gateway address
IP NETMASK <address> set the units network netmask
NETWORK INITIALIZE clear all known nodes and search for new nodes
NODE ADD search for and configure new nodes
NODE CONFIG <n> configure user information for a node
NODE DELETE <n> remove a node
NODE INITIO reinitialize a node's I/O hardware configuration
NODE LIST <n> view user and hardware configuration for nodes
NODE REPLACE <n> replace a node
SET ACO cutoff present alarms from affecting relays
SET AID <n> configures access identifier
SET ANSWER <n> set number of rings before the system answers
SET CHANNELS set user defined channels
To Next Page
Loading...
Need help?
General
