Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-90 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SNMP SET <comm name> set the SNMP SET community name
TRAPS ADD <n> add a new SNMP Trap recipient to the list of TRAP hosts
TRAPS DELETE <n> remove a host address from the list of TRAP hosts
TRAPS OCCURRED disable/enable the systems ability to send SNMP Occurred
Alarm TRAPS
TRAPS OFF disable the systems ability to send SNMP TRAP's
TRAPS ON enable the system to send SNMP TRAP's
TRAPS PERSISTENT disable/Enable the systems ability to send SNMP Persistent
Alarm TRAPS or set the Persistent Alarms reporting interval
TRAPS RETIRED disable/enable the systems ability to send SNMP Retired
Alarm TRAPS
TRAPS VERSION <V1|V2> change the version of SNMP TRAP's sent by the system
PRCONFIG LPS Displays the LPS system adjustment settings
alarm setpoints values, and configuration
parameters and the LPS hardware equipment
inventory for all bays and the MCA node.
PRCONFIG LPS N<#> Displays only the LPS hardware equipment
inventory for the specified bay.
PRCONFIG LPS N<#>-<#> Displays only the LPS hardware equipment inventory
for valid LPS bays and the MCA node that fall
within the specified range of LMS node numbers.
PRCONFIG LPS SETTINGS Displays only the LPS system adjustment settings
alarm setpoints values, and configuration parameters.
PRCONFIG LPS INVENTORY Displays only the LPS hardware equipment
inventory for all bays and the MCA node.
PRCONFIG LPS PCU Displays only the LPS hardware equipment
inventory of PCUs
PRCONFIG LPS DISTRIBUTION Displays only the LPS hardware equipment
inventory of bay distribution panels.
Programmed Command: Command Strings:
where: <> anything enclosed in brackets is optional
n is a valid number
t is a type A, B, F, G, L, R for Analog, Binary,
Function, Group, LED or Relay
To Next Page
Loading...
Need help?
General
