User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-89
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
CLR LOG clear alarm log
CLR MAIL clear your mail from memory
CLR POWER <n> clear power consumption data
CLR PROGRAM <tn> clear control programs
CLR RLY <n> de-energize relay
CLR STATS <tn> clear channel statistics
IP ADD <address> add a new host to the list of authorized hosts
IP ADDRESS <address> set the units IP address
IP DELETE <address> remove a host from the list of authorized hosts
IP GATEWAY <address> set the units gateway address
IP NETMASK <netmask> set the units network netmask
NETWORK INITIALIZE clear all known nodes and search for new nodes
NODE ADD search for and configure new nodes
NODE CONFIG <n> configure user information for a node
NODE DELETE <n> remove a node
NODE INITIO <n> reinitialize a node's I/O hardware configuration
NODE LIST <n> view user and hardware configuration for nodes
NODE REPLACE <n> replace a node
SET ACO cutoff present alarms from affecting relays
SET AID <n> configure access identifier
SET ANSWER <n> set number of rings before the system answers
SET CHANNELS set user defined channels
SET CLASS <n> set programmable alarm classifications
SET CMD <n> set programmable commands
SET COM set local comm port configuration
SET DATE <mm/dd/yy> set date where mm = month, dd = date, yy = year
SET DEFAULTS set system default parameters
SET EFF set Energy Management parameters
SET EMAIL set IP DNS server, SMTP Server, and return mail addresses
SET GATEWAY set GATEWAY port communications data rate
SET INFO <n> configure information pages
SET LED <n> turn LED on
SET LIMITS <tn> set channel alarm limits
SET LPS set LPS parameters
SET MAIL send mail to users
SET MODE modify configuration of TL1 port settings
SET PERIODS <tn> set time periods
SET PHONE set user phone numbers
SET PROGRAM <tn> configure control programs
SET REPORT set system alarm reporting parameters
SET RLY <n> energize relay
SET SEQUENCE set AC & Standby sequencer parameters
SET STATUS <n> configure status page
SET SYSTEM configure all settings
SET TIME <hh:mm:ss> set time where hh = hours, mm = minutes, ss = seconds
SET TIMEOUT <n> set user timeout
SET UNIT set unit name and number
SET USERS <n> configure a user
SET VI set Plant Voltage and Load Channels
SNMP GET <comm name> set the SNMP GET community name
SNMP OFF disable SNMP access
SNMP ON enable SNMP access