User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-221
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET PROGRAM
Description: Allows changing of the control programs.
Command Level: 5
Syntax: SET PROGRAM [channel_designator]
SE PR [channel_designator]
Comments:
Refer to the Configuration chapter in the separate Installation Manual for a discussion on
program lines.
When editing an existing control program use, Ctrl-R to copy the entire control program
text, or use Ctrl-Z to copy only one character from the existing text.
A program line can also be entered when a channel is configured. If the only change
required to an existing channel is to change the program line, the SET PROGRAM
command eliminates the need to proceed through an entire channel configuration
sequence.
Notes: This command could affect the alarm log information and therefore could also
initiate a phone call or Email message. Any user setting a program line will have his
name and this action recorded in the event log. Only one user at a time has access to
the system internal program line editor. If the program line editor is in use and another
user attempts to edit a program line, the user is notified that the editor is in use. When
using channel_designator, only channel types L, R, or F are valid.
Related Commands: PROGRAM
Example:
Command<5>: SET PROGRAM
Which Channel ? R0003
Control Program: None
Enter Program Line:
R0003=A0005&B0001&P1
To Next Page
Loading...
Need help?
General
