Emerson LMS1000 User Manual

Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-242 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET VORTEX INTERFACE
Description: Enables or disables the Vortex Interface.
Command Level: 6
Syntax: SET VORTEX INTERFACE
SE V IN
Comments: none
Notes: none
Related Commands: none
Example:
Command<6>: SET V INTERFACE
Vortex Power System interface is ACTIVE
Do you wish to deactivate Vortex Power System interface (Y or N): y
Currently communicating to Vortex MCA, cannot disable interface.
Vortex Power System interface is ACTIVE
___________________________________________________________________________________
Command<6>: SET V INTERFACE
Vortex Power System interface is ACTIVE
Do you wish to deactivate Vortex Power System interface (Y or N): y
Vortex Power System is DISABLED
___________________________________________________________________________________
Command<6>: SET V INTERFACE
Vortex Power System interface is DISABLED
Do you wish to activate Vortex Power System interface (Y or N): y
Vortex Power System interface is ACTIVE

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English