Emerson LMS1000 User Manual

Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-338 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Valid values for this parameter are as follows:
SA service-affecting condition
NSA nonservice-affecting condition
NULL request retrieval of alarm conditions for both of the above codes
Invalid values for this parameter return an error response with the error code IDNV.
<locn>
This parameter does not apply to LMS1000. The only valid value for this parameter is
NULL. Invalid values received for this parameter return an error response with the error
code IDNV.
<dirn>
This parameter does not apply to LMS1000. The only valid value for this parameter is
NULL. Invalid values received for this parameter return an error response with the error
code IDNV.
<tmper>
This parameter does not apply to LMS1000. The only valid value for this parameter is
NULL. Invalid values received for this parameter return an error response with the error
code INUP.
LMS1000 Response Format Variations:
<aidtype>
Valid values for an access identifier type response parameter are:
EQPT equipment
COM common
<ntfcncde>
This is the notification code parameter associated with a single alarm condition given in
this block. Valid values are the same as for the input format. Values are derived from
the NOTIFICATION CODE attribute of the LMS1000 channel or limit configuration with
which the alarm condition is associated.
<condtype>
This is the condition type parameter of the alarm condition being given in this block.
Values are derived from the CONDITION TYPE attribute of the LMS1000 channel or limit
configuration with which the alarm condition is associated.
<srveff>
This is the service effect parameter associated with a single alarm condition given in this
block. Valid values are the same as for the input format. Values are derived from the
SERVICE EFFECT CODE attribute of the LMS1000 channel or limit configuration with
which the alarm condition is associated.

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English