User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 4. Maintaining LMS1000 Page 4-3
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
8) Re-install the CPU circuit card by sliding the CPU circuit card into its mounting
position, ensuring the rear edge connector is firmly seated. Secure the circuit
card by tightening the retaining screw located on the circuit card assembly (this is
also the RS-232 Connector Grounding Screw). In a 582140000 LPS Power
System, note that if a modem is installed, it also contains a bracket with a
retaining screw.
9) Attach the top half of J4 to the bottom half , if previously removed.
10) Remove the grounding wrist strap.
11) 586505000/586505500 LMS Cabinet: Close the shelf door and secure with the
two captive fasteners (arrow on fastener points towards outside of cabinet).
or
582140000 LPS Power System: Close the bay's front door.
12) Re-apply DC input power to the LMS CPU circuit card.
To Next Page
Loading...
Need help?
General
