Emerson LMS1000 User Manual

User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 2. Operating LMS1000 Page 2-43
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Setting LPS Relay Test On: Use the command SET LPS SYSTEM RLYONTEST. This
command is available to a user with access to level 6 commands.
Setting LPS Relay Test Off:
Use the command SET LPS SYSTEM RLYOFFTEST.
This command is available to a user with access to level 6 commands.
Setting LPS Audible Alarm Cutoff Reset Time Period (NAG):
Use the command SET
LPS SYSTEM NAGTIMER. This command is available to a user with access to level 4
commands.
Setting LPS Custom Text Messages:
Use the commands SET LPS MESSAGE PCU,
SET LPS MESSAGE MCA, SET LPS MESSAGE ROUTER, SET LPS MESSAGE
DISTRIBUTION, SET LPS MESSAGE RELAY, and SET LPS MESSAGE CANIO_BD.
These commands are available to a user with access to level 6 commands.
Setting LPS Temperature Readings to Celsius:
Use the command SET LPS SYSTEM
USECELSIUS. This command is available to a user with access to level 6 commands.
Setting LPS Temperature Readings to Fahrenheit:
Use the command SET LPS
SYSTEM USEFAHRENHEIT. This command is available to a user with access to level 6
commands.
Changing the Password Issued by LMS to Gain Remote Access to the LPS:
Use
the command SET LPS PASSWORD. This command is available to a user with access
to level 6 commands.
Resetting (Updating) LPS Inventory:
Use the command SET LPS SYSTEM
UPDATEINV. This command is available to a user with access to level 6 commands.
Setting LPS Float Output Voltage:
Use the command SET LPS SYSTEM FLTVOLT.
This command is available to a user with access to level 6 commands.
Setting LPS Test/Equalize Output Voltage:
Use the command SET LPS SYSTEM
TSTEQVOLT. This command is available to a user with access to level 6 commands.
Setting LPS Test/Equalize Time Period:
Use the command SET LPS SYSTEM
TSTEQTIME. This command is available to a user with access to level 6 commands.
Setting LPS Auto-Equalize Multiplier:
Use the command SET LPS SYSTEM
EQMULTIPLIER. This command is available to a user with access to level 6 commands.
Setting LPS Temp Slope:
Use the command SET LPS SYSTEM TEMPSLOPE. This
command is available to a user with access to level 6 commands.
Setting LPS Temp Comp Max:
Use the command SET LPS SYSTEM
TEMPCOMPMAX. This command is available to a user with access to level 6
commands.
Setting LPS Temp Comp Min:
Use the command SET LPS SYSTEM
TEMPCOMPMIN. This command is available to a user with access to level 6 commands.
Setting LPS High Voltage Shutdown:
Use the command SET LPS SYSTEM HVS.
This command is available to a user with access to level 6 commands.

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English