Emerson Micro Motion 5700 - Configure the Display Backlight

2. If you turned on Auto Scroll, set Scroll Rate as desired.
• Default: 10
• Range: 1 to 30 seconds
Tip
Scroll Rate may not be available until you apply Auto Scroll.
7.1.5 Configure the display backlight
Display Menu > Configuration > Display Settings
ProLink III Device Tools > Configuration > Transmitter Display > General > Backlight
Field Communicator Configure > Manual Setup > Display > Backlight
You can control the intensity and contrast of the backlight on the display's LCD panel.
Procedure
1. Set Intensity as desired.
• Default: 50
• Range: 0 to 100
2. Set Contrast as desired.
• Default: 50
• Range: 0 to 100
7.1.6 Configure security for the display
Display
Menu > Configuration > Security > Display Security
ProLink III Device Tools > Configuration > Transmitter Display > Display Security
Field Communicator Configure > Manual Setup > Display > Display Menus
When using the display, you can require users to enter a password to do any of the following tasks:
• Enter the main menu
• Change a parameter
• Access alert data through the display
• Start, stop, or reset totalizers or inventories via the context menu
The display password can be the same or different from the totalizer/inventory context menu control
password. If different, the display password is used to reset, start, and stop totalizers or inventories using
Menu > Operations > Totalizers.
Procedure
1. Configure Password Required as desired.
Configure device options and preferences Configuration and Use Manual
March 2019 MMI-20025166
122 Micro Motion Model 5700 Transmitters with Configurable Outputs