Figure B-1: Service port inside transmitter wiring compartment
3. Start ProLink III.
4. Choose Connect to Physical Device.
5. Set parameters as shown here.
Parameter
Setting
Protocol Service Port
PC Port The number assigned to the USB port on your PC
6. Click Connect.
Need help?
If an error message appears:
• Ensure that you have specified the correct port on your PC.
• Ensure the transmitter service port is enabled at Menu > Configuration > Security > Service Port
Using ProLink III with the transmitter Configuration and Use Manual
March 2019 MMI-20025166
318 Micro Motion Model 5700 Transmitters with Configurable Outputs
To Next Page
Loading...
